Why does a wet crawl space matter if nobody goes in it?
Because the house above it is connected to it. The subfloor is wood sitting over the damp, the floor insulation and duct work are in the damp, and air moves from the space into the rooms above through every penetration in the floor. A wet crawl space is a wet layer of the house.
The structural side is the slow part. Joists and subfloor sheathing that stay damp for years lose strength, fasteners corrode, and growth establishes on the sheathing. None of that is visible from inside the house until a floor starts to feel different underfoot, at which point it has been going on for a long time.
The air side is what people notice first. The smell that comes up through a register or out of a closet floor on a humid day is crawl space air, and it is a reasonable signal that the space below is holding moisture. Chasing that smell indoors never finds anything, because the source is under the floor.
Is covering the ground really the main fix?
For moisture that comes out of the soil, yes, and it is unglamorous and effective. Bare earth evaporates continuously into the space; a continuous sheet over it, lapped and turned up at the walls, stops that at the source. It does nothing for standing water, which needs drainage and pumping.
The usual failure is a partial cover: a sheet that covers two thirds of the floor, is torn where somebody crawled over it, and stops short of the foundation walls. Moisture takes the path that is open to it, so a cover that is nearly continuous performs much worse than one that is continuous.
Ventilation works alongside it rather than instead of it. Vents that are clear and reasonably distributed let the space exchange air; vents blocked by soil, plantings or stored material turn the crawl space into a sealed damp box. Walking the outside of a house and looking at its vents takes five minutes.
- Find your crawl space access and check that it can actually be opened
- Walk the outside and clear anything blocking a foundation vent
- Check that downspouts discharge away from the foundation, not against it
- Look at whether the ground slopes toward the house anywhere
Can the subfloor above be saved?
Usually, if it is plywood or board sheathing and it is dried before it delaminates or loses strength. Pressed board sheathing is less forgiving and may have to be replaced in sections. Drying from below is the method, and it is the thing that most often keeps the finished floor upstairs in place.
Reading from below is what makes the call possible. A meter on the underside of the sheathing, taken at marked points on each visit, shows whether the drying is working and where the wet area really ends. From above, with a floor covering in the way, there is nothing to measure directly.
Where sheathing has to be replaced, it is cut out between joists and in sections, which means the finished floor above that area comes up too. Establishing how much of that is needed, as early as possible, is the difference between a localized repair and a floor replacement.
What makes a crawl space job come back?
Water from outside that was never addressed. Grading, downspouts, yard drainage and a sump that does not work are the four things that refill a crawl space every wet season. Pump it, dry it and cover the ground, and if the grading still slopes toward the house you will be back next winter.
This is where the valley's flat ground works against a household. Water that lands here has very little fall to carry it away, so it stands against foundations for days rather than running off. Getting a positive fall away from the building and keeping roof water moving away from it do more good here than almost any other measure.
The second repeat offender is storage. A crawl space used for storage gets its vents blocked, its ground cover torn and its access obstructed, and the cardboard and timber down there hold moisture. Clearing it out is part of the work, and keeping it clear is what makes the work last.