Why do these leaks go unnoticed for so long?
Because the appliance hides the evidence and the water goes downward and sideways into construction rather than out across the room. There is nothing to see on the floor, nothing to hear over the machine, and the first visible symptom is damage to something else: a cabinet, a floor covering, a ceiling below.
Scale is part of it too. A leak measured in ounces per cycle does not make a puddle; it soaks a small area of subfloor repeatedly and lets it partly dry in between. That cycle is unusually destructive, because it swells and dries particle board over and over until the material simply gives up.
The useful habit is a look rather than a wait. Once or twice a year, pull the washer forward, open the cupboard under the sink with a flashlight and run a hand along the back of the cabinet floor. Two minutes per appliance finds most of these while they are still trivial.
Why does cabinet material fail so badly?
Most cabinet carcasses and many cabinet floors are particle board or medium-density board with a thin finish. Those materials are wood fiber held together with adhesive, and water swells the fiber and breaks the bond. Once a board has swollen it has lost its structure permanently, whatever it reads on a meter afterwards.
This is why the honest answer about a swollen sink cabinet base is replacement rather than drying. A crew that dries it and leaves it has postponed the problem; the base will be soft, the fixings will not hold, and the smell often stays. Removing it also gives access to the floor underneath, which is where the water went.
Solid wood frames and plywood carcasses behave better and can frequently be dried and kept. Knowing which you have changes the plan, so it is worth looking at a cut edge in the kick space: layered plies dry out, pressed fiber does not.
- Close the angle stop to the appliance and stop running it
- Photograph behind and under the machine before anything moves
- Keep the failed hose, connector or fitting once it is removed
- Take everything out of the cabinets either side so the bases can be read
How much of the kitchen has to come apart?
Toe kicks and the cabinet bases that have swollen, plus the flooring over any area that reads wet and cannot be dried from below. Whole cabinet runs come out when the water has been running long enough to reach the backs and the fixings, which happens more often with ice maker lines than with anything else.
Where there is a crawl space, the outcome is often much better. Opening up below and drying the subfloor from underneath can leave a finished floor and a cabinet run in place, which is a very different job from lifting a kitchen floor. That is worth asking about before anybody starts cutting from above.
On a slab there is no below, so the covering has to come up over the wet area and the concrete is dried from the surface. Tile sometimes survives if it is well bedded and the grout is intact; anything glued to the slab generally does not.
Is appliance water treated as clean?
It depends on the appliance and on how long it has been there. Supply water from a fitting is clean at first. Dishwasher and washing machine drain water is not, and neither is water that has been sitting in a cabinet base with wood fiber and dust for a fortnight. The classification follows the worst of those.
Where it matters is in what gets kept. Clean water found early allows more to be dried in place. Drain water and long-standing damp mean porous materials come out and the surfaces get cleaned rather than only dried, which is a bigger job in a kitchen than it would be in a garage.
There is no need to guess at it on the phone. A crew can tell you on site which of those two situations you are in, and it changes the scope enough that it is worth having the conversation before any work is agreed.